Model 7007 is an updated version of an existing in-core amplifier.
The In-Core Amplifier is used for converting the current signal from In-Core Detector to voltage. After this, it does further signal processing including Dynamic Signal Compensation, Difference Compensation and Buffering, as well as comparison and driving alarm relay output.
The Tyne Model 7007 In-core amplifier is a state-of-the-art design using military grade components and the most current operational amplifiers. This contributes to the instrument having higher accuracy, linearity, and higher reliability. Also the display has been changed to a 7-segment digital display type instead of the older analog indication meters. The Tyne 7007 will directly display the Power Percentage and Trip Set Point in numerical format, instead of via older analog indicators.
The Tyne Model 7007 can be configured to be compatible with the previous Model 400 (with detector difference compensation) and Model 401 (without detector difference compensation). All the connectors on the rear panel have the same pin assignment and the same type of connector as Models 400 and 401.
模型7007是现有的核心放大器的更新版本。
核心放大器用于将电流信号从核心检测器转换为电压。在此之后, 进一步进行信号处理, 包括动态信号补偿、差分补偿和缓冲, 以及比较和驱动报警继电器输出。
Tyne 7007型核心放大器是一个先进的设计, 使用军用级组件和最新的运算放大电路。这有助于仪器具有较高的精度、线性度和较高的可靠性。此外, 显示器已被更改为7段数字显示类型, 而不是旧的模拟指示仪表。泰恩7007将直接显示功率百分比和行程设置点的数字格式, 而不是通过旧的模拟指标。
Tyne 7007可以配置为兼容以前的型号 400 (与探测器差补偿) 和型号 401 (没有探测器差补偿)。后面板上的所有连接器都具有相同的 pin 分配和型号400和401相同的连接器类型。
特征
兼容现有型号400和 401 CANDU 内芯放大器。
使用军用级部件。
用于显示电源百分比和设置的数字面板仪表。
使用了更新的运算放大器。
Specifications
| Mounting | Rack Mount. Overall dimensions: 3-1/2” height X 19” width X 12” depth |
| Relay | 4- form C 1A 60VDC |
| Linearity | Less than ± 0.25% of full range |
| Power Supply | 120VAC ± 10%, 60Hz ± 2Hz. |
| Power Consumption | < 150mA |
| Input Impedance | 200Ohm |
| Input Signal Range | 0.25µA to 5µA |
| Conversion Gain | Selectable |
| Resolution | Less than ± 0.05%. |
| Noise | < 1mV RMS at 0 to 100KHz |