Flange immersion heater / tubular max. 600 V 法兰浸入式加热器/管最大600伏
Characteristics
特点
Mounting:
安装：
flange
法兰
Form:
形式：
tubular
管状
Description
描述
Large Diameter Elements provide extra electrical insulation for superior dielectric strength. Because elements are .475″ diameter, they are suitable for line voltages up to 600 volts. In addition, element insulation is compacted to insure uniform heat transfer from coil to sheath and all bends are repressed to insure insulation integrity in this critical area.
大直径的元素提供额外的电绝缘优越的介电强度。因为元件是475英寸，它们是适合于线路电压高达600伏。此外，元件的绝缘被压缩，以确保从线圈到护套的均匀传热和所有弯曲被压制，以确保在这个关键区域的绝缘完整性。
Flanges are fabricated from 3/16″ minimum plate. Copper sheathed elements are silver soldered into brass flanges. Steel, Incoloy and stainless steel sheathed elements are welded into flanges of like materials.
法兰是从3 / 16“最小板制造。铜护套元素银焊接到黄铜法兰。钢、耐热镍铬铁合金和不锈钢铠装元件焊接在法兰材料。
Element Spacers, made from 304 stainless steel, maintain a uniform distance between elements, thus preventing hot spots where elements may otherwise touch.
元件间隔，由304不锈钢制成，保持一个元素之间的距离，从而防止热点，其中的元素可能会接触。
Terminals are 10-32 studs, spot welded to the element cold pin and insulated from the sheath with mica or silicone rubber. Elements are interconnected at the factory with copper or stainless steel bus bars. Cupped washers are furnished for field connections on heaters drawing less than 40 amps. Pressure connectors are furnished for larger heaters.
终端10-32钉，点焊到元冷销和绝缘护套用云母或硅橡胶。元素是在工厂与铜或不锈钢母线互连。杯状垫圈提供对加热器图小于40安培的现场连接。压力连接器提供给更大的热水器。
Moisture-Resistant Epoxy Seals are standard on copper sheathed elements. When the maximum fluid temperature will not exceed 250°F., epoxy seals can be furnished on steel, Incoloy and stainless heaters at no extra charge.
耐湿环氧密封件是铜护套元素的标准。当最大流体温度不会超过250°F.，环氧密封可以配置在钢、耐热镍铬铁合金和不锈钢加热器不额外收费。
Gaskets are furnished with each heater. A 1/16″ pressed fiber gasket is standard.
每一个加热器都配有垫圈。一个1 / 16“压纤维垫片是标准。
Flange immersion heater / tubular max. 600 V 法兰浸入式加热器/管最大600伏