Fiaxell Sàrl Kit for short stack Accessories 燃料电池测试平台短堆栈附件

Included: - Crofer 22 APU 2 X 90 X 90 mm grooved with standard pattern design - 2 X Inconel 600 tubes of 6 X 0.5 mm welded on the terminal plate for gas in/outlet and current/potential collection (with 2 X outside tabs for wires) - CuMn2O4 or NiO 5-10 micron protective plate coated on the terminal plate - End Inconel 601 plate for mechanical tightening and thermocouple holder (only one for two grooved terminal plates ordered)

- 2 X Inconel 601 plates at cell dimension for homogenous pressure distribution on the interconnect

-1 X Inconel 600 sheet of 100 X 50 X 0.1 mm for pressure distribution

- Thermocouple K with 1.5 mm SS316 hose

- soft mica sheet: 0.7 X 180 X 180 mm (can be delivered in pieces of 0.7 X 180 X 90 mm)

- 4 X alumium L (30X40X40 mm with extra scotch tape) for interconnect alignment

Ceramic cap 120 X 120 X 25 mm(pical) to close the bottom hole

Third tube welded on the air terminal for accurate adjustment of the fuel feeding in the stack

1 X Double side grooved plate (without tubes)(4pcs),

Thermocouple type K (30 meters with ceramic insulation sleeve for T< 900°) 

1 extra piece of soft mica sheet (175 X 225 X 0.5 mm); can be cut on request (disc, square, etc.)

2R-Cell (anode supported cell resistant to redox cycles) 50 X 50 mm, with/out holes and with/out cathode;

ECS (< 100 µm electrolyte supported 6ScSZ cell, resistant to redox cycles) 50 X 50 mm with/out holes, with/out cathode;

LSC ink (100 g): (organic solvent based, with low patial pressure) remains wet, to improve the electrical contact between interconnect and cathode with rollers

NiO ink (100 g): (organic solvent based, with low patial pressure) remains wet, to improve the electrical contact between interconnect and anode with rollers

CuMn2O4 ink (100 g): (water based) to paint or to brush on Crofer interconnect as protective layer against Chromium evaporation and to improve electrical conductivity (see website for contact resistance data)

NiO ink (100 g): (water based) to paint or to brush on Crofer interconnect as protective layer against Chromium evaporation and to improve electrical conductivity