The Bionetics Corporation, formerly Intek, Inc. 210R-XDT-TUL3/16(SS)(350F)(1/4"MNPT)-JB(SS)-HART-24V-ISB-5M 氮气流量计 210R-XDT-TUL3/16(SS)(350F)(1/4-MNPT)

Fluid: Nitrogen ( see Note 1 )

Customer Line Size: 1/4-inch

Customer Flow Range: 0 - 2 Nm^3/hr 

Calibrated Flow Range: 0.2 - 2 Nm^3/hr  

Temperature - Max Requirement: 163℃

Temperature - Operating Range: 15.5℃

Pressure - Max Requirement: 0.52 MPa-g

Pressure - Operating Range: 0.01 MPa-g

Fluid Viscosity: TBD

Fluid Density: 9.26 kg/m^3

 

Transducer Type: Loop tube 

Wetted Material: SS316/316L ( see Note 2 )

Shell Material: SS 316 

Process Connection: MNPT: 1/4" 

Local Display: 2x16 character LCD with selectable Flow Rate, Totalizer and Fluid Temperature 

Calibration Units: Nm^3/hr

Outputs: Passive 4 to 20 mA with HART

Input Power: 24VDC

Electronics Enclosure: NEMA 7 10x14x6 inches. Electronics are in a flame proof enclosure, approved for IECEX EXd IIB IP66 areas. 

Cable Length: 5M; （付费可升级至200 ft） 

Sensor tube size: 3/16-inch outside diameter with 0.02-inch tube wall, and 0.1475 inch inside diameter. 13 inches end to end.

Notes

1. Fluid - Calibration will be performed on the actual fluid if it can be handled safely and is readily available or if it can be supplied by Buyer. Otherwise, a substitute calibration fluid will be used, in which case a field calibration adjustment may be necessary to guarantee the highest levels of accuracy.

2. Wetted Material - The user is responsible for the selection of process-wetted materials in view of their corrosion resistance. Intek, Inc. makes no guarantees and assumes no liability for the corrosion resistance of the materials selected here for the application described above.

3. ISB - The electronics and sensor listed in item 2 above are approved hazardous environments, sensor meets ATEX certification for Ex ia IIC T4 Ga areas, enclosure meets ATEX approved for IECEX EXd IIB IP66 areas.

4. Transducer design temperature - 163C Max., ATEX approval valid to temperatures less than or equal to 120C